Industrial Adhesive

COLD APPLIED BITUMEN ADHESIVE

TIKI RBA COMPOUND (C P R X) is a cold applied rubberised bituminous adhesive in the form of an emulsion of brushable consistency.

Ideally recommended for fixing of thermocole, PU foam sheets, PVC tiles and other cellular insulation materials used in Cold storage/Chilling Plants. Apply TIKI RBA COMPOUND by using a stiff haired brush / squeegee on both surfaces and allow to break for 20-25 minutes when the painted film turns dark brown to black. Apply firm pressure over the area to be stuck to expel any trapped air.

CPRX Compound™ is a rubber based Bituminous Adhesive of brush-able consistency.

CPRX Compound™ is recommended for the fixing of expanded/extruded Polystyrene (thermocole), insulex soft boards and fibre glass insulation slabs for all type of structures where bituminous adhesive is acceptable

• It may be used to stick insulation sheets on to concrete, timber, metal or other insulation sheets.
• It is particularly suitable for .use in cold storage to ensure good adhesion to walls and ceilings and may also be used for sticking thermocole for insulation of refrigeration pipe work.
• Special grades of CPRX Compound™ are available for fixing tiles, linoleum, etc.

• Cold Adhesive, hence heating not required.
• Brushable and easy to apply.
• High bond strength.

• Thoroughly clean both surfaces which are to be stuck together to ensure removal of dust and other loose particles from concrete, plaster or other surfaces.
• Apply CPRX Compound™ by brush on both surfaces and leave the emulsion to “break” for 15-20 minutes. When the applied film turns dark brown to black, both the surfaces, which are to be stuck together, should be pressed firmly.
• Press firmly with even pressure over the whole area which is to be stuck to ensure that no air remains entrapped. The adhesive will hold the sheet in place immediately but no attempt should be made to pull the sheet before 24 hr. CPRX Compound™ requires 24 hr to obtain the full bond strength. So no further work should be done on the completed surface for at least 24 hr .

• CPRX is a non toxic rubber based bituminous adhesive.
• Not harmful if inhaled. • Use goggles and hand gloves during application.
• Clean hands with warm soap water after application.